Filter
Top Products
45
SETUP Setup SETUPSETUP SETUPSETUP
Adjusting the Convergence Manually
The Convergence feature gives you more control over the picture’s
convergence than the Flash Focus feature, allowing you to fine-tune the
convergence.
1 Press MENU to display the Menu.
2 Move the joystick B or b to highlight the Setup icon and press
.
3 Move the joystick to highlight Convergence and press .
A pattern of white crosses appears, with a yellow around one
of the crosses. Aligned crosses (which do not need adjustment)
look white and have little or no red or blue showing. Crosses that
are not aligned show red or blue shades beyond their edges.
You can scroll up and down through the 9 x 7 field of crosses to
manually converge all portions of the screen.
4 Using the joystick, move the to surround a cross that you want
to adjust. Press . The changes to red.
5 If the cross that you selected has red edges, move the joystick
until the red image is replaced with a white cross. Once you have
finished this (or the cross does not have red edges), press . The
changes to blue.
6 If the cross you selected has blue edges, move the joystick until
the blue image is replaced with a white cross. Once you have
finished this, press . The changes to yellow again.
7 Repeat steps 4 to 6 to adjust other crosses. When finished, press
MENU to exit the Setup Menu.
✍ Before using the manual Convergence, you must first perform Flash Focus
(as described on page 44).
For details on using the
Setup Menu, see page 83.
z
DA4X.book Page 45 Tuesday, April 23, 2002 2:48 PM