Sony KP-57WV600 Projection Television User Manual


 
35
SETUP Setup SETUPSETUP SETUPSETUP
Notes on Using This Connection
To Do This ... Do This ...
Watch the satellite receiver Press TV/VIDEO repeatedly to select the VCR input (VIDEO 1 in the
illustration).
The VCR may need to be turned on and set to the satellite receiver input.
Watch the VCR Press TV/VIDEO repeatedly to select the input to which the VCR is connected
(VIDEO 1 in the illustration).
Set up the TV remote control
to operate the satellite
receiver or VCR
If you have a non-Sony VCR or satellite receiver, you must program the
remote control. See Programming the Remote Control on pages 51-52.
Activate the TV remote
control to operate the satellite
receiver or VCR
For the satellite receiver, press SAT/CABLE FUNCTION. For the VCR, open the
outside cover, as shown on page 50. Then set the A/V slide switch to the
position you programmed for the VCR.
Control satellite receiver and
VCR functions with the TV
remote control
See Operating a Satellite Receiver on page 53 and Operating a VCR on
page 53.
Label video inputs to easily
identify equipment connected
to the TV
See the instructions for setting up Video Labels on pages 83-84.
DA4X.book Page 35 Tuesday, April 23, 2002 2:48 PM