Filter
Top Products
14
Advanced Operation - Advanced Presetting
Besides the explanation in the section “Automatically Tuning the TV using the Remote Control“, by following the
instructions below, this projection TV also searches and stores automatically all available channels using just one button of
the projection TV set and one button of the remote control.
Automatically Tuning the TV
1 Push up the flap on the front of the projection TV to reveal the front
control panel.
2 Press and hold in the button on the TV set for some seconds, until
a menu appears automatically on the screen asking you to check that
antenna is connected.
3 Confirm that the antenna is connected and then press the OK button
on the remote control.
The automatic tuning starts and the message "AUTO
PROGRAMME" flashes on the screen.
This procedure could take some minutes. Please, be patient and
do not press any button, otherwise the automatic tuning will not
be completed.
When the automatic tuning procedure is complete, the Programme
Sorting menu appears on the screen:
• If you do not wish to change the channel order, press the MENU
button on the remote control to exit and return to the normal TV
screen.
• If you wish to change the channel order, proceed in the same way as
described in the chapter "Changing the Programme Order of the TV
channels", section b).
Note: To stop the automatic tuning, press the MENU button on the
remote control.
Advanced Operation - Advanced Presetting
S
RM
892
PROGR
MENU
1
4
7
2
5
8
0
3
6
9
VIDEO TV
Please confirm that
antenna is connected
Confirm: OK
Please confirm that
antenna is connected
Confirm: OK
PROG
1
AUTO PROGRAMME
AUTO PROGRAMME
SYS
B/G
CH
C 26
LABEL
- - - - -
01GB.fm Page 14 Monday, June 4, 2001 3:47 PM