Sony RDR-GXD310 DVD Recorder User Manual


 
82
2
Select “Digital Out,” and press ENTER.
3 Select “On,” and press ENTER.
4 Set the digital output signal.
Dolby Digital (DVDs only)
Selects the type of Dolby Digital signal.
MPEG (DVD VIDEO only)
Selects the type of MPEG audio signal.
DTS (DVD VIDEO only)
Selects whether or not to output DTS signals.
48kHz/96kHz PCM (DVD VIDEO only)
Selects the sampling frequency of the audio
signal.
b Notes
“48kHz/96kHz PCM” setting has no effect when audio
signals are output from the LINE 2 OUT (R-AUDIO-
L) jacks. If the sampling frequency is 96kHz, signals
are simply converted to 96kHz analog signals and
output.
When you use the DIGITAL OUT (COAXIAL or
OPTICAL) jack to listen to MPEG audio signals and
set “MPEG” to “MPEG” in “Audio” setup, no sound
will come from your speakers if you select one of the
Surround TVS modes.
On Normally select this position.
Off The influence of the digital circuit
upon the analogue circuit is
minimal.
D-PCM
Select this when the recorder is
connected to an audio component
lacking a built-in Dolby Digital
decoder. The surround effects of
output signals are determined by
the “Downmix” setting item in
“Audio” setup.
Dolby
Digital
Select this when the recorder is
connected to an audio component
with a built-in Dolby Digital
decoder.
PCM
Select this when the recorder is
connected to an audio component
without a built-in MPEG decoder.
If you play MPEG audio sound
tracks, the recorder outputs stereo
signals via the DIGITAL OUT
(COAXIAL or OPTICAL) jack.
MPEG Select this when the recorder is
connected to an audio component
with a built-in MPEG decoder.
Audio - Audio Connection
Digital Out : On
Dolby Digital :
48kHz/96kHz PCM : 48kHz/16bit
DTS :
MPEG : PCM
Off
D-PCM
On Select this when the recorder is
connected to an audio component
with a built-in DTS decoder.
Off
Select this when the recorder is
connected to an audio component
without a built-in DTS decoder.
48kHz/
16bit
The DVD video audio signal is
converted to 48kHz/16bit and
output.
96kHz/
24bit
All signals containing 96kHz/
24bit are output without
conversion. However, the signals
are output at 48kHz/16bit if
copyright-protected signals are
contained.