Filter
Top Products
11
3 Press the Component Select
button for the desired
component.
The SET indicator and the
selected Component Select
button lights up.
4 Press the Number buttons
to enter the four-digit
component code number.
5 Press ENT.
The SET indicator and the
Component Select button light
turns off.
If the Component Select button
flashes five times before
turning off, it means that the
setup is incomplete. Start over
from Step 2.
Continued
Notes
• If you press a component code
number that is not on the table in the
supplied “Component Code
Numbers,” or if you press a button in
the wrong order, the Component
Select button flashes five times, and
then turns off. Check the component
code number, and try setting it again.
• If you don’t input anything into the
Commander within 20 seconds
between each step, the setup
procedure will be canceled. To set the
code, start over from Step 2.
•
If you press SET while setting the
component code, all code numbers will
be lost, and the setup procedure will
be canceled. Start over from Step 2.
To cancel setup, press SET.
TV
SET
SATDVDTV CBL
TAPE
CDVCR AMP
TV TV