Filter
Top Products
20
2 Press and hold the
Component Select button
for the component whose
signals are to be “learned”
for over 3 seconds.
To teach signals to the SYSTEM
CONTROL buttons, press and
hold the desired SYSTEM
CONTROL button for over 3
seconds.
Both the SET indicator and the
selected Component Select
button light up.
When you “teach” signals to
the SYSTEM CONTROL
buttons, only the SET indicator
lights up.
When the SET indicator lights
up, you can release the
Component Select button. The
SET indicator flashes and the
selected Component Select
button lights up (Learning
function standby).
When you “teach” signals to
the SYSTEM CONTROL
buttons, you can release the
SYSTEM CONTROL button
when the SET indicator lights
up. The SET indicator lights
up, but the SYSTEM
CONTROL button does not
light up.
DVD
SET
SATDVDTV CBL
TAPE
CDVCR AMP
SET
SATDVDTV CBL
TAPE
CDVCR AMP
Programming signals of another
remote control — Learning
Function (continued)
Programming remote
control signals to the
Component Select buttons
and System Control
buttons
You can “teach” one operating
procedure to a Component Select
button and System Control
buttons, so that when you press
the Component Select button and
System Control buttons, the
operation is also automatically
done.
For example, if it is necessary to
switch the input selection of an
amplifier to DVD when you use a
DVD player, “teach” an input
select signal to the DVD button.
After “learning,” the input
selection of an amplifier is
automatically switched to DVD
just by pressing DVD. (For this
operation, the amplifier should
first be turned on.)
Example: To “teach” the DVD
input remote control signal of
your amplifier to the DVD
Component Select button of the
Commander
1 Follow Steps 1 to 2 (page
16).