Filter
Top Products
21
Continued
3 Press and hold the button
on the other remote control,
until the SET indicator
lights and all the
Component Select buttons
flash again.
During data transfer, only the
SET indicator stays lit, and the
Component Select button turns
off.
If the SET indicator flashes
five times
It means that “learning” is
incomplete. Repeat Steps 2 and 3.
4 Repeat Steps 2 and 3 to
“teach” remote control
signals to other buttons.
5 Press SET to finish
“learning.”
Notes
• If you do not perform Learning steps
within 20 seconds at any point during
the process, Learning mode ends.
• If you do not perform Step 3 within
10 seconds after Step 2, the Learning
procedure returns to Step 1. Repeat
from Step 2 while the Component
Select button is lit.
To cancel “learning,” press SET.
If another signal has already
been “learned” by that
button
The SET indicator flashes twice,
and the Commander takes no
action, returning to its state after
SET was pressed and held in Step 2.
Either “teach” to another free
button, or clear the already
“learned” function (page 22) and
start over from the beginning.