Filter
Top Products
SFM1
Page 14 Installation Manual
Securing the Flat Panel to the Wall Mount
WARNING: At least (2) qualified personnel are strongly recommended for installation of this product.
Failure to do so could result in serious injury and possible damage to the flat panel.
1. Raise the flat panel with the LEFT and RIGHT mounting brackets secured to the flat panel and insert
the top hooks from each bracket to the rod on the wall plate (Figure 15).
Figure 15. Securing the Flat Panel
Lateral Shift Adjustment
1. Make any lateral shift adjustment and lock it by tightening the two (2) ¼”-20 Phillips screws found on
the bottom of the mounting brackets (Figure 16).
2. Use the foot leveler to adjust your plasma.
CAUTION: Do not over tighten the ¼”-20 screws to the rods.
Figure 16. Lateral Shift Adjustment
W
all Plate
TOP
BOTTOM
L
ateral Shift