Filter
Top Products
SFM1
Page 6 Installation Manual
Flat Panel Mount Location
WARNING: INVERT THE FLAT PANEL PLACE IT ON A SOFT, FLAT SUFRACE TO PREVENT DAMAGE TO
THE FLAT PANEL. USE A BLANKET, FOAM, ETC. FAILURE TO DO SO WILL RESULT IN
DAMAGING THE FLAT PANEL. DO NOT LAY THE FLAT PANEL ON THE FLOOR WITHOUT ANY
PROTECTION TO THE GLASS. THE FLAT PANEL IS HEAVY AND FRAGILE. AT LEAST (2)
QUALIFIED PERSONNEL ARE STRONGLY RECOMMENDED FOR INSTALLATION OF THIS
PRODUCT. FAILURE TO DO SO COULD RESULT IN SERIOUS INJURY AND POSSIBLE DAMAGE
TO THE FLAT PANEL.
1. Once the flat panel is inverted, use a measuring tape to find the center of your flat panel measuring
from outside to outside of the chassis (Figure 1).
2. Using a pencil lightly mark the center of your flat panel (Figure 2).
C
L
L
C
Figure 1. Flat Panel Mount Location Figure 2. Marking the Mount
Mounting Bracket Positioning
1. Install the nylon spacers to the mounting points on the flat panel (Figure 3)
2. Lay the left and right mounting brackets (stamped arrows facing out) (Figure 4).
To
p
of Flat Panel
I
nverted Flat
P
anel
M
easurin
g
Ta
p
e
B
ottom of Flat
P
anel
Inverted Flat
Panel
M
ark the Center
of the Flat Panel