Filter
Top Products
21
Tuning your TV to the VCR
Master Page : Right
filename[010get.fm] model name1[SLV-SE610G] model name2[SLV-SE710G]
model name3[SLV-SE710I] model name4[SLV-SE810G]
[3-065-677-11 (1)]
Getting Started
Step 5 : Tuning your TV to the VCR
If your TV has a Scart (EURO-AV) connector, see page 22.
If your TV does not have a Scart (EURO-AV) connector
Follow the steps below so that your TV will properly receive the video
signals from your VCR.
1
Press RF CHANNEL on the VCR lightly.
The factory-preset RF channel appears in the display window.
The VCR signal is output through this channel to the TV.
2
Turn on your TV and select a programme position for the VCR
picture.
This programme position will now be referred to as the video
channel.
3
Tune the TV to the same channel
shown in the VCR display window so
that the picture on the right appears
clearly on the TV screen.
Refer to your TV manual for TV
tuning instructions.
If the picture does not appear clearly,
see “To obtain a clear picture from the
VCR” below.
PROGRAM +/–
RF CHANNEL
AUTO
SET UP
RF CHANNEL
SONY VIDEO CASSETTE RECORDER
continued