Sony SLV-SE810G VCR User Manual


 
22
Tuning your TV to the VCR
Master Page : Left
filename[010get.fm] model name1[SLV-SE610G] model name2[SLV-SE710G]
model name3[SLV-SE710I] model name4[SLV-SE810G]
[3-065-677-11 (1)]
To check to see if the TV tuning is correct
Set the TV to the video channel and press PROGRAM +/ on the VCR. If
the TV screen changes to a different programme each time you press
PROGRAM +/, the TV tuning is correct.
To obtain a clear picture from the VCR
If the screen does not appear clearly in step 3 above, press PROGRAM +/
so that another RF channel appears. Then tune the TV to the new RF
channel so that a clear picture appears.
If your TV has a Scart (EURO-AV) connector
4
Press RF CHANNEL.
You have now tuned your TV to the VCR. Whenever you want to
play a tape, set the TV to the video channel.
1
Press RF CHANNEL on the VCR lightly.
The factory-preset RF channel appears in the display window.
The VCR signal is output through this channel to the TV.
2
Press PROGRAM +/ to set the RF channel to OFF, and press RF
CHANNEL again.
RF channel set up is complete.
AUTO
SET UP
RF CHANNEL
PROGRAM +/
RF CHANNEL
AUTO
SET UP
RF CHANNEL
AUTO
SET UP
RF CHANNEL
PROGRAM