Filter
Top Products
85
Troubleshooting
Additional Information
Master Page : Right
filename[010addi.fm] model name1[SLV-SE610G] model name2[SLV-SE710G]
model name3[SLV-SE710I] model name6[SLV-SE810G]
[3-065-677-11 (1)]
Timer recording
The VIDEO Plus+ menu
or the TIMER menu does
not appear.
• Check that TIMER OPTIONS in the OPTIONS-2 menu is
set correctly (see page 77).
The VPS/PDC function
does not operate
properly.
• Check that the clock and the date are set correctly.
• Check that the VPS/PDC time you set is the correct one
(there might be a mistake in the TV programme guide). If
the broadcast you wanted to record did not send the good
VPS/PDC information, the VCR will not start recording.
• If the reception is poor, the VPS/PDC signal might be
altered and the VCR might not start recording.
Synchronized Recording
The SYNCHRO REC
button turns off while
recording or does not go
back to recording
standby mode.
• The tape has reached its end. Insert a new tape and press
SYNCHRO REC again.
The Synchronized
Recording function does
not work.
• The connected equipment was not turned off.
Turn off the connected equipment and press SYNCHRO
REC again.
• There was a power failure. Press SYNCHRO REC again.
The programme recorded
with the Synchronized
Recording function is
incomplete.
• If the settings for timer recordings and Synchronized
Recording overlap, the programme that starts first has
priority and the second programme starts recording only
after the first programme has finished.
• There was a power failure. Press SYNCHRO REC again.
Others
A tape cannot be
inserted.
• Check that a tape isn’t already in the tape
compartment.
The remote
commander does not
function.
• Make sure you are pointing the remote commander at
the remote sensor on the VCR.
• Replace all the batteries in the remote commander
with new ones if they are weak.
• Make sure the [TV] / [VIDEO] remote control switch
is set correctly.
The SMARTLINK
function does not
work.
• Check that your TV complies with SMARTLINK,
MEGALOGIC, EASYLINK, Q-Link, EURO VIEW
LINK, or T-V LINK.
• Make sure you use the Scart cable to connect the
VCR and your TV.
• Make sure the Scart cable is connected securely.
The tracking meter
does not appear on the
TV screen.
• The recording condition of the tape is very poor and
tracking cannot be adjusted.
• The tracking meter does not appear when playing
back an NTSC-recorded tape.
Symptom Remedy
continued