Sony SLV-SX740N VCR User Manual


 
57
Recording TV programmes using the timer
Basic Operations
To use the VCR after setting the timer
To use the VCR before a recording begins, just press ?/1. The indicator
turns off and the VCR switches on. Remember to press ?/1 to reset the VCR
to recording standby after using the VCR.
You can also do the following tasks while the VCR is recording:
Reset the counter (page 40).
Display tape information on the TV screen (page 43).
Check the timer settings (page 63).
Watch another TV programme (page 43).
To use the Auto Tape Speed function
In step 2 above, press m to select AUTO. When you are recording a
programme in the SP mode and the remaining tape length becomes shorter
than the recording time, the recording tape speed is automatically changed to
the LP mode. Note that some noise will appear on the picture when the tape
speed is changed. To operate this function correctly, the “TAPE SELECT”
setting in the USER SET menu must be accurate (see page 72).
Tips
To set the line input video source, you can also use the INPUT SELECT button.
Even if you set TIMER METHOD* to SHOWVIEW in the EASY OPERATION
menu, you can set the timer manually. Press MENU to select TIMER
PROGRAMMING, then go to step 2.
To check, change, or cancel the programme setting, see “Checking/changing/
cancelling timer settings” on page 63.
Notes
When setting the timer with VPS/PDC* signals, enter the start and stop times
exactly as indicated in the TV programme guide. Otherwise, the VPS/PDC
function will not work.
If the VPS/PDC* signal is too weak or the broadcasting station failed to transmit
VPS/PDC signals, the VCR will start recording at the set time without using the
VPS/PDC function.
The and indicators flash in the display window when you press ?/1 with
no tape inserted.
The VPS/PDC function* is automatically set to off for the timer recording of a
satellite programme.
* not available on SLV-SE640N and SE440K