Filter
Top Products
75
Troubleshooting
Additional Information
Master Page : Right
filename[010ADDI.fm] model name1[SLV-SE510B] [3-065-671-E1 (1) GB]
Timer recording
The VPS/PDC function
does not operate
properly.
• Check that the clock and the date are set correctly.
• Check that the VPS/PDC time you set is the correct one
(there might be a mistake in the TV programme guide). If
thebroadcastyouwantedtorecorddidnotsendthegood
VPS/PDC information, the VCR will not start recording.
• If the reception is poor, the VPS/PDC signal might be
altered and the VCR might not start recording.
Synchronized Recording
The ENR SYNCHRO
button turns off while
recording or does not go
back to recording
standby mode.
• The tape has reached its end. Insert a new tape and press
ENR SYNCHRO again.
The Synchronized
Recording function does
not work.
• The connected equipment was not turned off. Turn off the
connected equipment and press ENR SYNCHRO again.
• There was a power failure. Press ENR SYNCHRO again.
The programme recorded
with the Synchronized
Recording function is
incomplete.
• If the settings for timer recordings and Synchronized
Recording overlap, the programme that starts first has
priority and the second programme starts recording only
after the first programme has finished.
• There was a power failure. Press ENR SYNCHRO again.
Canal Plus
You c an not set t he
channel as Canal Plus in
the REGLAGE DES
CHAINES menu.
• Check that DECODEUR/LIGNE2 in the OPTIONS-2
menu is set to DECODEUR (see page 70).
You cannot watch the
Canal Plus programme
when the VCR is in
standby mode.
• Check that DECODEUR/LIGNE2 in the OPTIONS-2
menu is set to DECODEUR (see page 70).
• Make sure the Canal Plus PERITEL cable is plugged
securely.
The Canal Plus
programme is always
recorded scrambled.
• Make sure the Canal Plus PERITEL cable is plugged
securely.
• Check that DECODEUR/LIGNE2 in the OPTIONS-2
menu is set to DECODEUR (see page 70).
• Check that this channel is set as Canal Plus in the
REGLAGE DES CHAINES menu (see page 36).
Others
A tape cannot be inserted. • Check that a tape isn’t already in the tape compartment.
Theremotecommander
does not function.
• Make sure you are pointing the remote commander at the
remote sensor on the VCR.
• Replace all the batteries in the remote commander with
new ones if they are weak.
• Make sure the [TV] / [MAGN] remote control switch is set
correctly.
“L2” does not appear in
the display window.
• Check that DECODEUR/LIGNE2 in the OPTIONS-2
menuissettoLIGNE2(seepage70).
Symptom Remedy
continued