Filter
Top Products
68
Controlling Your TV or AV
Amplifier (Receiver) With
the Supplied Remote
By adjusting the remote signal, you can
control your TV with the supplied remote.
If you connect the player to an AV amplifier
(receiver), you can control the volume with
the supplied remote.
Notes
• Depending on the connected unit, you may not be
able to control your TV or AV amplifier
(receiver) using some of the buttons below.
• If you enter a new code number, the code number
previously entered will be erased.
• When you replace the batteries of the remote, the
code number you have set may be reset to the
default setting. Set the appropriate code number
again.
Controlling TVs with the remote
1 Slide the TV/DVD switch to TV.
2 Hold down [/1, and enter your TV’s
manufacturer code (see “Code
numbers of controllable TVs” below)
using the number buttons.
3 Release [/1.
When the TV/DVD switch is set to TV,
the remote controls the following:
* If you use number buttons to select the TV’s
programme position, press -/-- followed by the
number buttons for two-digit numbers.
Code numbers of controllable TVs
If more than one code number is listed, try
entering them one at a time until you find the
one that works with your TV.
[/1 Turns the TV on or off
VOL +/– Adjusts the volume of the TV
WIDE MODE Switches to or from the wide
mode of a wide TV
VOL +/–
TV/VIDEO
Number
buttons
TV/DVD
switch
-/--
WIDE MODE
[/1
Number buttons,
-/--*
Selects the programme
position of the TV
TV/VIDEO Switches the TV’s input
source between the TV and
the player
The button works even if the
TV/DVD switch is set to
DVD.
Manufacture Code number
Sony (default) 01
Grundig
11
Hitachi 24
Loewe 06, 45
Nokia
15, 16, 69
Panasonic 17, 49
Philips 06, 07, 08
Saba
12, 13
Samsung 06, 22, 23
Sanyo
25
Sharp 29
Telefunken 36
Thomson 43
Toshiba 38