Filter
Top Products
77
Settings and Adjustments
Notes
• Even if you set “48kHz/96kHz PCM” to “96kHz/
24bit,” the sampling frequency is converted to
48 kHz/16 bit when a “SURROUND” mode (page
55) is selected.
• The analog audio signals from the LINE OUT L/
R (AUDIO) 1/2 jacks and 5.1CH OUTPUT jacks
are not affected by this setting and keep their
original sampling frequency level.
Settings for the Speakers
(SPEAKER SETUP)
To obtain the best possible surround sound,
set the size of the speakers you have
connected and their distance from your
listening position. Then use the test tone to
adjust the volume and the balance of the
speakers to the same level.
This setting is effective when connecting the
speaker with 5.1 CH OUTPUT jacks (page
25).
Select “SPEAKER SETUP” in the Setup
Display. To use the display, see “Using the
Setup Display” (page 70).
The default settings are underlined.
To return to the default setting
Select the item, then press CLEAR. Note that
only the “SIZE” setting does not return to the
default setting.
◆SIZE
Selects the size of the speakers.
• FRONT
LARGE Normally select this position.
SMALL Select this when the sound
distorts or the surround effects
are difficult to hear.
SPEAKER SETUP
DISTANCE:
BALANCE:
LEVEL:
OFF
TEST TONE:
FRONT:
CENTER:
YES
LARGE
(
REAR
)
LARGE
LARGE
REAR:
SUBWOOFER:
SIZE:
,continued