Filter
Top Products
9
3 Install the unit with the supplied
mounting screws.
Cautions
• Since the unit is quite heavy, be careful when
installing the unit.
• Hold the unit horizontally when installing it,
since the disc tray may open if the unit is shaken.
• To reduce the risk of fire, do not place any
heating or cooking appliance beneath this unit.
• Install the unit so that its AC power cord can be
connected directly to a wall outlet. Do not use a
converter or extension cord.
• Be sure that the AC power cord has no slack
when using the unit, since the cord acts as an FM
wire antenna. If the AC power cord has some
slack, wind up the slack on the cord hook.
• The unit has a built-in ferrite bar antenna for AM
radio reception. Check the condition of AM
reception before fixing in position.
• Install the unit as far as possible from a source of
noise (for example, refrigerator, microwave
oven, fluorescent lamp, etc.).
Mounting
screw
Setting the Clock
1 Plug in the unit.
“AM 12:00” will flash in the Clock Display
Window.
2 Press CLOCK for a few seconds.
You will hear a beep and the hour digits
will start to flash in the Clock Display
Window.
3 Press RADIO TUNE/TIME SET –, m(fast
reverse) or +, M(fast forward) until
the correct hour appears in the Clock
Display Window.
4 Press CLOCK (or ENTER) once.
The minute digits will flash.
5 Press RADIO TUNE/TIME SET –, m(fast
reverse) or +, M(fast forward) until
the correct minute appears in the Clock
Display Window.
6 Press CLOCK (or ENTER) once.
You will hear two short beeps and the
seconds start counting from zero.
Tips
• To set the current time rapidly, hold down
RADIO TUNE/TIME SET –, m(fast reverse) or +,
M(fast forward).
• To set the current time exactly to the seconds,
adjust the minute function in step 6 and then
press CLOCK (or ENTER) to synchronize it with a
time signal (such as the telephone time signal).
• In the 12-hour system: “AM 12:00” = midnight.