Filter
Top Products
11 (GB)
Location and Function of Parts and Controls
Remote Commander RM-971
1 POWER ON switch
Press to turn on the display.
2 STANDBY button
Press to turn the display to the standby mode.
3 MUTING button
Mutes the sound.
4 DISPLAY button
Displays the input signal information and the picture
mode at the display panel. Press again to clear it.
If this displayed information is left undisturbed for a
short time, it will disappear automatically.
5 INPUT1 button
Selects the signal input from the INPUT1 connectors.
6 INPUT2 button
Selects the signal input from the INPUT2 connectors.
VOL CONTRAST
ENTER
PFM
MUTING
123
456
78
0
9
DISPLAY STBY
POWER
ID MODE
ON
INPUT 1 INPUT 2 VIDEO OPTION
RGB/YUV
BRIGHT
H SHIFT V SHFT H SIZE
ON SET
RM-971
OFF
VSIZE
CHROMA
S/VIDEO ASPECT
MENU
6
5
2
1
3
4
0
7
qs
8
9
qa
qd
qk
ql
w;
qj
qh
wa
ws
wd
qf
qg
7 RGB/YUV button
Press to select the format matching that of the input
signal connected to the INPUT1 or INPUT2
connector. Each press toggles between RGB and
YUV.
8 S/VIDEO button
Selects the signal input from the COMPOSITE IN
connector or Y/C IN connector from among the
VIDEO connectors. Each press toggles between
COMPOSITE IN and Y/C IN.
9 M/m/</,/ENTER buttons
The M/m/</, buttons move the menu cursor
(yellow) and set values, etc. Pressing the ENTER
button enters the selected menu or set contents.
q; BRIGHT +/– button
Adjusts the brightness when the picture mode is set to
“User 1-3”.
Press this button and then adjust the brightness with
the M/m or </, button 9.
qa V SHIFT button
Adjusts the vertical centering. Press this button and then
adjust the vertical centering with the M/m button 9.
qs H SHIFT button
Adjusts the horizontal centering. Press this button and
then adjust the horizontal centering with the M/m or
</, button 9.
qd VOLUME +/– button
Adjusts the volume.
qf OPTION button
Selects the signal input from the optional adaptor
(except BKM-B10) when you install it in the unit.
qg VIDEO button
Selects the signal input from the COMPOSITE IN
connector or Y/C IN connector from among the
VIDEO connectors.
qh Number buttons
Press to enter the index number.
qj ASPECT button
Changes the aspect ratio of the picture (Wide Mode).
qk MENU button
Press to make the menu appear. The menu is no
longer displayed when this button is pressed again.
When using the MENU button to return to the previous
menu level, see “Initial Setup menu” on page 23 (GB).