Filter
Top Products
16 (GB)
Connections
Attaching the Ferrite Core
When attaching to the AC power cord
1 Attach the ferrite cores to both ends of the AC
power cord and close the ferrite cores until they
click.
2 Wind the stopper round the cord so that the ferrite
cores do not slide.
3 Tighten the stopper and cut the surplus.
Within 10 mm (
13
/32 inch)
Within 10 mm (
13
/32 inch)
Within 10 mm (
13
/32 inch)
Within 10 mm (
13
/32 inch)
Within 10 mm (
13
/32 inch)
Within 10 mm (
13
/32 inch)
When attaching to the cables
1 Attach the ferrite core to the end of the cable
closer to this unit, closing it until it clicks.
2 Wind the stopper round the cord so that the ferrite
core does not slide.
3 Tighten the stopper and cut the surplus.
Notes
•When you connect this unit to various pieces of
equipment using the RGB/YUV connectors, use the
specified cable.
SMF-400 (D-Sub 15P - 5 BNC)
SMF-410 (D-Sub 15P - D-Sub 15P)
When you connect a cable to any of the terminals
listed below, attach the ferrite core provided before
using the cable.
AUDIO (INPUT1)
AUDIO (INPUT2)
•You are cautioned that this unit will not be in
compliance with the EMC limits unless the ferrite
core is installed on the interconnecting wire.