Filter
Top Products
40 (GB)
When you name the setting, follow the steps below.
7 Press
M
/
m
to move the cursor (yellow) to “Name
Set” and press ENTER again.
The following menu appears on the display panel.
User Memory
Save
Name Set :MEM 01
0123456789ABCDEFGH
IJKLMNOPQRSTUVWXYZ
abcdefghi jklmnopqr
stuvwxyz()[]<>+– /
=% &; : . ' , End
set
,,, toselect, to
ENTER
Character list
8 Select a character or symbol in the character list
with
M/m/</,
and press ENTER. The selected
character is input. If you make a mistake, select
[
<
] on the screen to backspace the cursor one
character, then correct the error.
When [MENU Function] (page 23 (GB)) on the Initial
Setup menu has been set to [Return], the M/m buttons
on the Remote Commander move the cursor left and
right. To make the M/m buttons move the cursor up and
down, set [MENU Function] to [On/Off].
9 Repeat step 8 and after you have finished entering
the name, select “End” and press ENTER.
The menu returns to the Save menu.
Calling Up a Stored Setting
1 In the User Memory menu, press
M
/
m
to move the
cursor (yellow) to “Load” and press ENTER.
The following menu appears on the display panel.
,toselect item
User Memory
Load
Restore
MEM 01
MEM 02
MEM 03
MEM 04
MEM 05
MEM 06
MEM 07
2 Move the cursor to the Memory Number (01~ 20)
of the setting that you want to recall using the
M
/
m
buttons.
The stored adjustment value is recalled.
To restore the value in effect before the recall,
move the cursor to “Restore.”
Using the Memory Function
3 Press the ENTER button.
The display returns to the User Memory screen
used to store and recall adjustment values.