Filter
Top Products
Using the menu system
12 Using the menu system O
Tuning
The Tuning menu allows you to tune your receiver automatically
or manually and also change the order of the programmes on
display. During these procedures you may be requested to enter
your PIN. Refer to page 11 for information.
Note: After tuning, your receiver will continually monitor broadcast
information to check for new channels. Should a new channel become
available, it is detected and automatically added to your programme list.
Normally it will then be available to view. However, if you notice a new
channel that you are unable to view, please tune it in manually using the
‘Manual Tune’ procedure as explained above.
Auto Tune
This tuning method captures and stores all available channels.
1
With ‘Tuning’ highlighted in the main menu, press the OK
button. Enter your PIN if requested and the Tuning display
appears with ‘Auto Tune’ highlighted. Press the OK button
to select. The Auto-Tune prompt display appears.
2
Press the B button to select ‘Yes’, then press the OK
button to begin autotune procedure. A display appears
showing a tuning progress bar and the number of services
found.
3
When autotune has ended, a completion menu appears
indicating the number of TV and Radio channels that have
been captured and stored.
4
Press the OK button to remove the display and view the
first channel captured.
Manual Tune
This tuning method allows you to capture and store individual
services.
1
With ‘Tuning’ highlighted in the main menu, press the OK
button. Enter your PIN if requested and the Tuning display
appears with ‘Auto Tune’ highlighted. Press the V or v
button to highlight ‘Manual Tune’, then press the OK
button to select. The Manual Tune display appears
showing a list of all the channels previously captured and
stored.
2
Press the Red button to display the previous five channels
or the Green button to display the next five channels.
3
Press the V or v button or enter a channel number to
select the programme number of your choice, then press
the OK button. The Tuning screen is displayed. Press the
b button to highlight ‘Select Search’ then press the V or v
button to begin searching.
4
When a service is found the display now shows a list of
captured channels. Press the V or v button to highlight the
channel you wish to store, then press the OK button.
5
If the channel you want is not in the displayed list, press
the B button to highlight ‘Select Search’, then press the V
or v button to continue searching.
6
Once you have stored your desired channel, press BACK
button repeatedly to return to the main menu.
Text.fm Page 12 Tuesday, April 27, 2004 8:21 AM