Filter
Top Products
Instruction Manual
9
Method 2: Connect the NAS enclosure directly to your computer (Standard
Access)
1. Connect an Ethernet cable (included) from the LAN port on the
enclosure to an available LAN port on your computer.
2. Set your computer IP address to an IP address on
the same subnet as the NAS Enclosure.
The default NAS IP address is: 192.168.0.2
As a result for initial setup, we recommend setting
your computer IP address to: 192.168.0.1
3. Access the web interface by browsing the NAS enclosure default
IP address with your web browser: http://192.168.0.2
4. You can get access to your NAS enclosure at IP address 192.168.0.2
Step 4. Initialize Your Hard Drives
Access Web Interface
1. Open the web browser on the connected computer and type the NAS IP address, or
device name into the address bar.
Default IP address: http://192.168.0.2
Default Device Name: http://S352BMU3N
2. The NAS Enclosure uses user accounts to limit access. An administration account is
used for conguration and restricted access. You may be prompted to enter the NAS
administration user name and password. By default the user name and password for
the administration account are both “admin” as listed below.
Default Administration Account User name: admin
Default Administration Password: admin
Enter the user name and password and click the OK button.