Filter
Top Products
Chapter 5: Advanced Motherboard Setup
5-15
BMC Enable/Disable
JPB1 is used to enable or disable the
BMC (Baseboard Management Con-
trol) chip and the onboard IPMI con-
nection. This jumper is used together
with the IPMI settings in the BIOS.
See the table on the right for jumper
settings.
BMC Enable
Jumper Settings
Setting Denition
Pins 1-2 BMC Enabled
Pins 2-3 Disabled
Watch Dog Enable/Disable
Jumper JWD controls the Watch Dog
function. Watch Dog is a system moni-
tor that can reboot the system when a
software application hangs. Jumping
pins 1-2 will cause WD to reset the sys-
tem if an application hangs. Jumping
pins 2-3 will generate a non-maskable
interrupt signal for the application that
hangs. See the table on the right for
jumper settings. Watch Dog must also
be enabled in BIOS.
Watch Dog
Jumper Settings
Setting Denition
Pins 1-2 Reset
Pins 2-3 NMI
Open Disabled
USB Wake-Up (JPUSB1)
Use the JPUSB1 jumper to enable system
"wake-up" via a USB device. This jumper
allows you to "wake-up" the system by
pressing a key on the USB keyboard or by
clicking the USB mouse of your system.
The JPUSB1 jumper is used together with
the USB Wake-Up function in the BIOS.
Enable both the jumper and the BIOS set-
ting to activate this function. See the table
on the right for jumper settings and jumper
connections.
Note: The default jumper setting is "Dis-
abled". When the "USB Wake-Up" function
is enabled, it will be active on all USB ports.
USB Wake-Up
Jumper Settings
Jumper Setting Denition
Pins 1-2 Enabled
Pins 2-3 Disabled (Default)