Swann SW242-6T4 DVR User Manual


 
Digital Video Recorder User Manual
5
1 Power plug 2 Alarm in/alarm out
3 RS485 4 USB interface
5 LAN port 6 Audio in 1-2
7 S-video output 8 Audio output
9 Video output 10 Video in 1-4
Fig2.2 Back Panel
2.4 Remote Controller Introduction
2.4.1 Use Remote Controller
Notice: Please note that Remote Controller is not a standard part of this DVR. Your package might not include it.
Steps of using the Remote Controller are described as below:
STEP1 Put the battery into the Remote Controller.
1. Open the battery cover of the Remote Controller.
2. Put into two AAA batteries whose model is 7 and make sure that they are not inserted upside down.
3. Put back the battery cover.
STEP2 Check the followings if the Remote Controller does not work.
Whether the battery’s anode and cathode are in the correct position or not.
Whether the power of the battery is ran out or not.
Whether there is barrier between the Remote Controller and DVR or not.
Whether there are some signals which transmitted by other devices disturbing the Remote Controller or
not.
Notice: If the possibilities above are excluded, please contact with vendor to change the Remote Controller.