Filter
Top Products
12.10 Load Default
22 Rackmount DVD/CD Duplicator User’s Manual
12.10 Load Default
The
Load Default function resets all settings to factory default values. It is
recommended that you reset to the default values if the DVD/CD Duplicator fails
to function properly after you make changes to the original configuration. To
execute the
Load Default function, follow the steps below:
1. Press and hold down the
(ESC) button for two (2) seconds until you
hear a beep.
2. Press the down arrow to display
12.10 Load Default.
3. Press the
(ENT) button.
The system displays the message:
Load Default Config? Yes.
4. Press the (ENT) button.
The system starts loading the default data. When the loading operation is
complete, the system displays the message:
Load Default OK.
5. Press the (ESC) button twice, then press the down arrow to return
to the main menu.
The system displays
1.Copy.
12.11 CD+G
The
CD+G function enables or disables CD+G (karaoke CD) format support. The
default setting is
OFF.
For more information about CD+G discs, see item 7 in the FAQ on page 27.
12.12 ISRC & MCN
The
ISRC & MCN function enables or disables ISRC and MCN format support.
The default setting is
OFF.
12.13 CD-Text
The
CD-Text function enables or disables the copying of CD-Text discs. The
default setting is
OFF.
For more information about CD-Text discs, see item 8 in the FAQ on page 27.
12.14 Use Big Block
This function is not available in the 2U Rackmount Duplicator.
Note: The CD+G value must be set to OFF before you can use the Track
Extraction features.