25
To Replace program...
To Clear program...
Review, Replace or Clear Program Contents:
(Recording is not in progress)
or
Important notes when using DSS Receiver
• When recording programs via DSS Receiver, DSS Receiver must be left on.
• When recording programs via an antenna or cable, DSS Receiver must be turned off.
Press ADD/DLT.
*Important: If a remote control button does not work when pressed,
press the VCR button on the remote and try the button again.
1
2
3
Press
to select number.
To cancel a Timer
Recording in progress...
Repeat Step 2 (p. 24)
to set new programs.
Press PROG
to end the programming.
Hold down STOP in VCR mode for
a few seconds to cancel the Timer
Recording.
(The “TIMER” Indicator goes out
on Multi Function Display.)
• Any future daily or weekly recording
will be performed as programmed.
Notes
• If you are using a Cable Box, the VCR’s channel for Timer Recording must be set to
the Cable Box input channel and Cable Box must be manually set to the desired
channel. Cable Box power must be left on.
• 2 minutes before Timer Recording is performed, “PLEASE PREPARE FOR TIMER
REC” appears and Timer Indicator flashes.
Be sure a cassette with record tab is loaded and DECK is in Stop mode.
• If a power interruption occurs while programming the timer, the timer program(s) may be
canceled. If “TIMER PROGRAMS WERE LOST DUE TO POWER INTERRUPTION”
appears on-screen, please re-enter the timer programs.
• If the start time for Timer Recording comes up during recording and playing back,
Timer Recording will not be performed.
Press PROG
to display Program List.
4
P DT STA
R
TST
O
P
CH
SPD
1 13 2
:
00p 3
:
20p 02 SLP
2 14 7
:
00p 7
:
30p 10 SP
3
-- --
:
-- --
:
--
--
--
4
-- --
:
-- --
:
--
--
--
SELECT :
SET:SET
EXIT : PROG
PDTSTA
R
TST
O
P
CH
SPD
1
-- --
:
-- --
:
--
--
--
2 14 7
:
00p 7
:
30p 10 SP
3
-- --
:
-- --
:
--
--
--
4
-- --
:
-- --
:
--
--
--
SELECT :
SET:SET
EXIT : PROG
P DT STA
R
TST
O
P
CH
SPD
1 13 2
:
00p 3
:
20p 02 SLP
2 14 7
:
00p 7
:
30p 10 SP
3
-- --
:
-- --
:
--
--
--
4
-- --
:
-- --
:
--
--
--
CANCEL
:
ADD/DLT
SELECT :
SET:SET
EXIT : PROG
VCR
Operation