Filter
Top Products
English - 18 -
Channel Search
In manual channel scan, the number of the multiplex is
entered manually and only that multiplex is searched
for the channels. For each valid channel number, signal
level and signal quality are shown on the screen.
In both manual and auto search any existing channel
in the database is not re-stored to avoid redundant
duplicates of that channel.
Clear Service List (*)
(*) This setting is visible only when the Country option
is set to Denmark, Sweden, Norway or Finland.
Use this setting to clear channels stored. Press “
” or “ ”
button to select Clear Service List and then press OK. The
following OSD message will be displayed on the screen:
Highlight NO and press OK to cancel. Select Yes by
pressing “ ” or “ ” button and press OK to delete all
of the channels.
First Time Installation
The user can use this item to load default settings,
which were loaded to the receiver at the factory.
To install factory settings, highlight “First Time
Installation” menu item and press “OK” button, then
you will be asked whether or not to delete the settings.
Selecting “Yes” by pressing “OK” button while “Yes” is
highlighted will delete the existing channel table.
Then you will be asked to confi rm for deleting all
channels and settings:
By selecting Yes and pressing the “OK” button, the
existing channel table will be deleted. After factory
settings are loaded, “First Time Installation” menu
will be displayed.
The menu which is displayed for language selection
appears on the screen at fi rst. By using “
” or “ ”
buttons, select the desired language option, and press
OK button to activate.
Afterwards “First time installation” OSD will appear
on the screen. By pressing “
” or “ ” buttons, select
the Country you want to set and press “OK” button
(* only for EU countries).
Press the “OK” button to start installation. After search
is completed for digital channels, a message asking
whether to search for analogue channels appears
on the screen.This process is same as described in
Automatic Search section. .
Analogue TV Menu System
Picture Menu
Mode
For your viewing requirements, you can set the related
mode option.
Press “
” or “ ” button to select Mode . Press “ ”
or “ ” button to choose from one of these options:
Natural, Cinema and Dynamic.
Contrast/Brightness/Sharpness/Colour/
Hue
Press “ ” or “ ” button to select the desired option.
Press “ ” or “ ” button to set the level.
Note : Hue option can only be visible when the TV receives
an NTSC signal.
Colour Temp
Press “ ” or “ ” button to select Colour Temp .
Press “ ” or “ ” to choose from one of these options:
Normal, Warm and Cool.
Note :
• For normal colours, select Normal option.
• Setting Warm option gives white colours a slight red
stress.
• Setting Cool option gives white colours a slight blue
stress.
Noise Reduction
If the broadcast signal is weak and the picture is
noisy, use Noise Reduction setting to reduce the
noise amount.
MB45_[GB]_1205UK_IDTV_BRONZE11_19882W_10066964_50164988.indd 18MB45_[GB]_1205UK_IDTV_BRONZE11_19882W_10066964_50164988.indd 18 15.02.2010 14:40:1815.02.2010 14:40:18