Filter
Top Products
The following selections can be made in this sub-menu:
5.4.1 Switching DiSEqC on or off
DiSEqC (Digital Satellite Equipment Control) is a digital signal that can control the functions
of DiSEqC-compatible components via the antenna connection.
If your external installation features DiSEqC components, you should enable the DiSEqC
control function:
> When this entry is highlighted, use the OK key to switch the DiSEqC function on or
off.
5.4.2 Adjusting the Switching Matrix and LNB Properties
The menu reflects the four switching criteria of the DiSEqC control.
Your receiver is pre-programmed to receive ASTRA broadcasts on switch setting A/A, and
EUTELSAT signals on setting B/A of a Multiswitch. Should the switching matrix of your exter-
nal receiving unit be set up differently, or should you wish to receive satellite signals other
than those mentioned, you can adjust the receiver settings as follows:
> Use the up/down arrow keys to select the DiSEqC switch position (1-4) that you
wish to use for allocation to a satellite (e.g. A/B 3 No Satellite), and highlight the
appropriate entry.
> Press the OK key to confirm.
A list of several satellites will be displayed, from which you can make your selection.
> Use the up/down arrow keys to select the appropriate satellite.
Pressing the up/down arrow keys will move the marker by one line at a time, up or
down, while the left/right arrow keys will take you to the previous or following
pages respectively.
Should the satellite you are looking for not be included in the list, please select one of
the spare settings, which are marked User 1 to User 15.
> Confirm by pressing the OK key.
The highlighted entry will now be inserted in the Menu >Settings>LNB at the pre-
viously selected position
In this way, you can continue to customise the Menu>Settings>LNB until all the informa-
tion in this menu correspond to those of your receiving unit. For those switiching criteria you
do not require you should select the setting No Satellite.
5.4.3 Additional Settings
Now that the switching matrix of your DVB receiver has been adjusted to conform to your
external reception equipment, you should also check on the other settings for your receiving
equipment, and adjust the settings where necessary.
> Use the left/right arrow keys to mark the entry Check LNB.
> Using the up/down arrow keys to move around the field Check LNB, select the
satellite position (1-4) that you wish to adjust resp. check on; mark the entry Pro-
ceed in blue.
16
bed_anl_DigiBox_Viaccess_englisch.qxd 13.08.01 11:42 Seite 16