Filter
Top Products
6.6 TV/Radio selection
Your receiver has been pre-programmed with a selection of radio as well as TV programmes.
When selecting a radio programme, the TV image is switched off, and only the radio pro-
gramme name is displayed.
> Use the TV/Radio key to select radio mode.
The receiver will automatically go to the last radio programme selected.
> Press the TV/Radio key again, and the last TV programme selected will be display-
ed again.
6.7 Return to previous programme selected
> Press the Back key on the remote control to view the last programme previously sel-
ected.
> Press the same key again to return to the programme viewed before the change.
6.8 Displaying Time and Programme Information
This function allows you to view information about the programme currently selected.
> Press the blue key in order to display information on the current programme.
The bottom of the screen will now display the current time, the current channel as well as the
name of the current programme, including the starting and end times of the programme, if
these details are broadcast by the channel concerned.
6.9 Additional Programme Information
In as far as such information is provided by the broadcasters, you can obtain additional pro-
gramme information by pressing the Programme Info key.
> Pressing the yellow key will open a further viewing window on your screen.
Information relating to the current programme will be displayed.
> Now press the OK key to obtain information about the following programme
> Pressing the yellow key again will cause the on-screen information to disappear.
6.10 Transponder Information
> Press the green key Transponder Info to display data relative to the transponder
selected.
> Press the same key again to return to the normal video display.
6.11 Video text
Where broadcast, video text will be sent through to your TV set. Use the remote control of
your TV set to utilise the video text function. Should your TV set experience problems, e.g.
video content and text are superimposed, you should set your receiver to FBAS mode
(Point 5.3)
6.12 Sub-titles
The symbol displayed in the on-screen information window will indicate when sub-titles
are being broadcast.. If you have enabled the Sub-title function as per Point 5.3, these will
be displayed automatically if they are being broadcast in the language selected (Point 5.3).
If you have not enabled the Sub-title function, or if sub-titles are only being provided in
other languages, you can also enable their display manually as follows:
> Press the red function key.
A list of the sub-title languages currently being broadcast will be displayed.
> Use the up/down arrow keys to select the language required.
20
bed_anl_DigiBox_Viaccess_englisch.qxd 13.08.01 11:42 Seite 20