Filter
Top Products
16
Operation
3M™ Digital WallDisplay
©3M 2003. All Rights Reserved.
Shutdown
Press the On/Off Button on the bottom center panel of the 3M Digital WallDisplay unit.
The lamp will turn off and the projector arm will return to its housing. The
On/Off Button will flash amber as
the arm closes.
Note: There is a 30-second reset period before the On/Off Button will function again. During this period,
the On/Off Button will flash red.
The fan will continue to run for approximately five minutes to cool the unit.
Note: If the 3M Digital WallDisplay will not be moved or disconnected, leave the Master Power Switch on
for your convenience.
Do not turn off the
Master Power Switch or unplug the power cord before pressing the On/Off
Button.
After the On/Off Button is pressed, the fan continues for approximately five minutes to cool
the 3M Digital WallDisplay.