Filter
Top Products
38
Maintenance
3M™ Digital WallDisplay
©3M 2003. All Rights Reserved.
Replacing ProjectionScreen
Replacing the 3M Digital WallDisplay screen is very simple.
1. Turn off the 3M Digital WallDisplay and disconnect the power cord from the wall outlet.
2. Remove the right and left side bezels. There are two ways to remove it. Either snap it off or insert a
screwdriver into the notch located on the sides of each bezel, near the top. The bezel will easily snap on
and off for screen replacement.
3. Slide the screen straight out of the open side. Be sure to allow approximately 4 feet of clear space on
either side of the 3M Digital WallDisplay to do this.
4. Insert new screen into the open side and slide into place. Ensure that the screen is centered before
replacing the side bezels. The bezels have ribs on the inside that could damage the screen if it is not
centered.
5. Insert the bottom of the bezel first, then snap bezel back into place.