Filter
Top Products
Remote control
EN
8
Programming the remote control
Automatic code search
This method can be used to automatically find the most
appropriate code for your appliance.
1. Switch on the appliance you wish to use the remote
control with.
2. Press the relevant button for this appliance on the
remote control, and while holding this button down,
press the button until the light or the appliance
buttons of the remote control come on. Release
both buttons.
3. Point the remote control at the appliance and press
PLAY.Wait until the light stops flashing. If the
appliance has not gone into standby mode, press the
PLAY button again to continue the search for the
next set of codes.
Repeat this operation until the appliance goes into
standby mode.There are around 20 sets of codes.
4. When the appliance goes into standby mode, switch
it on again without using the remote control. Press
the
REV button as many times as is required to
return the appliance to standby mode.
5. Press the
STOP button and hold it down until the
light or the appliance buttons of the remote control
go off.
Note:You can cancel the programming operation at any time by
pressing the EXIT button.
Manual programming
This method involves carrying out a manual search for
the codes to be used for controlling your other
appliance.
1. Switch on the appliance you wish to use the remote
control with.
2. Press the relevant button for this appliance on the
remote control, and while holding this button down,
enter one of the codes relevant to your make of
appliance (see the list of codes at the end of this
manual). If the light or the appliance buttons of the
remote control flash you have entered the wrong
code or it is not possible to program the remote
control.
3. Point the remote control at the appliance and press
the relevant button (
VCR, DVD, etc). Press the
standby button. If the appliance does not go into
standby mode, try another code.
Depending on the year of manufacture and the type of
appliance, some functions may not be available. Certain
codes may cover more functions than others.Test the
functions you can control and, if appropriate, try other
codes. Note here the code(s) which work best.
When you change the remote control’s batteries,
remember to reprogram it.
VCR
DVD
SAT
AUX
AMP
42pb120S4-en 2/07/04 11:32 Page 8