Filter
Top Products
Switching on
EN
9
Please respect the environment and the relevant regulations. Before you
dispose of batteries or accumulators, ask your dealer whether they require
special recycling and if he is able to take them back.
Follow the instructions on this page to switch on the TV set and the
remote control.
1. Install two LR06 or AA batteries in the remote control.
Precautions on using batteries:
- Only use the battery types specified.
- Make sure you use the correct polarity.
- Do not mix new and used batteries.
- Do not use rechargeable batteries.
- Do not expose batteries to excessive heat, throw them on the fire, recharge them or try
to open them, as this could cause them to leak or explode.
- Remove the batteries from the remote control if you are not using it for a long period
of time (several weeks).
2. Connect the TV set to a mains socket.
The set should only be connected to an AC supply. It must not be
connected to a DC supply. If the plug is detached from the cord, do
not, under any circumstances, connect it to a mains socket, as there
is a risk of electric shock.
Equipment for the UK is supplied with a mains cable fitted with a
moulded plug.This plug contains safety components and must not be
replaced by one sold by general retailers. It is fitted with a fuse that
protects your television. If your set has stopped working, the fuse
may have blown. If it has, replace it with an identical ASTA or BSI
certified (BS1362) 13-amp fuse.
3. Connect the outside aerial or cable network to the antenna
connector (labelled ANT) on the rear panel of the TV set.
The aerial socket can be used for connecting an external aerial or other equipment fitted
with a modulator (video recorder, satellite receiver, etc.).We recommend that you do not
connect other equipment (video recorder, satellite receiver, etc.) to your TV set to begin
with, so as not to complicate the set-up procedure with this additional equipment.
Connect them when you have finished setting up the channels.
4. Switch the TV set on by putting the main power switch located at
the back on the ON position, then pressing the power button on the
front panel.
The first time you switch on the TV set, the language selection menu
appears.
13A
100 ~ 240 V
50/60 Hz
Mains socket in
continental Europe
42pb120S4-en 2/07/04 11:32 Page 9