Filter
Top Products
Further information
28
There is no sound, or it can hardly be heard
• Ensure that the plugs of the various cables are securely fitted into the sockets.
• If you connect an appliance (such as an amplifier) that includes a DTS or Dolby Digital
decoder, check that the input parameters of the appliance are correctly defined.
• According to the type of connection, select the appropriate setting in the sound menu of
your player and tick the DTS or Dolby Digital options.
The remote control unit does not work
• Did you press the key corresponding to the appliance to be controlled (DVD,VCR,TV)? Is
the appliance to be controlled manufactured by a brand other than one in the Thomson
group (Thomson, Brandt, Ferguson, Saba,Telefunken)?
• Point the remote control unit toward the front of the player.The maximum distance from
which it can be used is 8 metres. Ensure that there is no obstacle (object, animal) between
the remote control unit and the player.
• Remove batteries and hold down one or more keys for several minutes to drain the
microprocessor inside the remote to reset it. Reinstall batteries and try remote again.
• The batteries are fully discharged and must be replaced.When you insert the replacement
batteries, ensure you align their positive and negative polarities correctly (page 2).
The invalid icon appears on the screen
• Some functions are not accessible because they depend on the disc playing.
The language of subtitles or dialogues is not the one you selected at the time
of the initial setup
• When the language of subtitles or dialogues is not available on the disc, a default language
is selected automatically.You can select the subtitles or dialogue language through the
information banner (
INFO key) or the language selection menu on the player.
The menu language is not the one you wanted
• In STOP mode select the Languages menu on the DVD player, then the Player Menu
function. Select a language from among those available, OK.
If you forget your password
• Open the player’s disc tray and ensure that there is no disc on it. Close the tray.The
player menu is now displayed on the TV screen. Now press the
STOP button on your
player and hold the
STOP key on the remote control unit down for two seconds.The
code you choose is deleted. Please refer to page 20 to create a new code.
Reconfiguring your player’s initial set-up
• Open the player’s disc tray and ensure that there is no disc on it. Close the tray.The
player menu is now displayed on the TV screen. Now press the
NEXT button on your
player and hold the
STOP key on the remote control unit down for two seconds.All
settings you made since the initial set up will be cancelled.The player is reconfigured to
the state it was in upon delivery (manufacturer’s settings).
If you switch your player off and then on again, the original choice of languages appears.
Refer to page 7 of this booklet to set up the player again.
2_DTH231_EN 21/08/03 15:51 Page 28