Filter
Top Products
37
GB
GB
S peakers
System audio quality
Speaker setting is required only if you use the 6 cinch jacks on the rear of the DVD player. In that
case, the Dolby Digital / MPEG-2 decoder sends a decoded 5.1 signal to the amplifier (for further
information, refer to figures 3 and 5 on pages 14-15). Speaker setting is required only at installation.
Depending on the amplifier and connected speakers, confirm your set-up with the menu below.
Refer to pages from 13 to 15 for connections.
This interactive menu page allows you to,
• Select the speakers you have connected.
• Adjust their audio volume and respective delay.
• Configure all the decoding values for the Dolby Digital and audio multichannel MPEG 2 for your
speakers.
• Display the room with the position and number of speakers (including the subwoofer).
• Choose the size and quality of your speakers by clicking twice on each speaker (function available
for Dolby Digital DVD discs only).
• Adjust the delay between the front and surround speakers, and for the central speaker according to
its position compared to the front speakers.
• Test the setting by running a test sound (“pink noise”).
If you do not have the 5 recommended speakers (+1: the Subwoofer) for multichannel surround
sound,
• Click twice on the icon corresponding to your missing speakers (subwoofer and/or surround
speakers): they disappear from the screen. Multichannel sound will now be distributed across the
remaining speakers. As you purchase more speakers, you can re-activate them one by one.
DTH4500-GB 7/09/00 13:34 Page 37