Technicolor - Thomson DVD Player + TV Set + VCR DVD VCR Combo User Manual


 
Connections and Setup
8
EN
Tuning in a video channel on your TV
If your television is not fitted with a Scart socket, you were unable to connect it to the AV1
socket of the DVD/VCR using a Scart cable (not supplied) as shown on page 4, step 3.In this
case, you must make below settings before you start the automatic channel set-up (page 9).
The output frequency of this appliance is set at UHF channel 60.
If channel 60 is already used by another TV station, or if the picture is distorted, you can change
the transmitter channel of your VCR.Stages 7 ~ 13 will show you how to change the output
frequency of your DVD/VCR.
Make sure that you have correctly installed the appliance as described earlier in this book.
1. Turn on your TV.
2. Press to turn on the appliance and then press the VCR button on the remote control.
3. Insert a pre-recorded video tape into the VCR and press PLAY on the remote control.
4. Select a TV channel number on which you wish to watch videos.
Don’t worry if you don’t have a video tape to play at this stage! If you switch the appliance on
and continue stages 5 ~ 6, instead of seeing video playback tune your TV until you see a
bright blue screen.
5. Tune this channel until the video picture is sharp and the sound is clear.
6. Store this channel on your TV.
You will need to look at the TV instruction book if you do not know how to do this.
Note: Only carry out stages 7 ~ 13 if you cannot obtain clear video playback as described in stages 1 ~ 6.
7. Select a TV channel number on which you wish to watch videos. Make sure that the
DVD/VCR is in standby by pressing on the remote control (only the clock will be
displayed).
8. Press CHANNEL- or CHANNEL+ on the front of
the appliance for more than 4 seconds. RF60 will
appear on the front display.The picture opposite will
be displayed on the TV screen.
9. Press CHANNEL- or CHANNEL+ to select another video channel.You may select any
channel number between 22 and 68.
10. Select a TV channel number on which you wish to watch videos.
11. Tune this channel so that a bright blue screen appears.
12. Store this channel on your TV.
13. Press on the front of your appliance when you have finished.
Make sure that you have correctly installed the appliance and successfully tuned in a dedicated
video channel on your TV. If you do not tune in a dedicated video channel on your TV you will be
unable to view and record video tapes!
i
RF CHANNEL 60
P
SET
R
DTH6100U_EN 18/07/03 13:46 Page 8