Filter
Top Products
27
GB
GB
Speakers
Speaker icons display and size
• If the speaker is connected, display the corresponding icon on-screen. If it is not connected, delete
the icon.
• If the speaker is capable of reproducing low frequencies (<100 Hz), select the large icon.
• If the speaker provides poor quality at low frequencies (<100 Hz), select the smaller icon.
• If the subwoofer is not connected, select the large icon for the front speakers (LH/RH).
Note: The speaker icon size setting (large/small) has no effect on DVD discs in
MPEG 2 Multichannel Audio.
Delay between speakers
• Delay settings allow you to adjust the virtual space between front and rear speakers. This means
you can reproduce the sound space of a movie in your home.
• If the surround speakers or the central speaker cannot be installed at the same distance from the
listening position as the front speakers, change the delay to obtain a better surround effect.
• If the distance (D2) from the listening position to the central speaker or the distance (D3) from the
listening position to the surround speakers is greater than or equal to the distance (D1) from the
listening position to the front speakers, no adjustments are required. Otherwise, adjust the settings
according to the chart below:
D1 D1
D2
D3 D3
C
L R
SR
SL
SW
Surround
speaker (L)
Surround
speaker (R)
Subwoofer
Front speaker (L) Front speaker (R)
Centre
Speaker Delay time
Distance between
D1 and D2/D3
1.3 ms
approx. 150 cm
Central 2.6 ms
approx. 100 cm
speaker (D2) 3.9 ms
approx. 150 cm
5.3 ms
approx. 200 cm
5.3 ms
approx. 200 cm
Surround
10.6 ms
approx. 400 cm
speakers (D3)
15,9 ms
approx. 600 cm
Relative volume setting between speakers
When listening to the test signal, adjust the volume of the central, surround (LH), surround (RH)
speakers and the sub-woofer so that their volume is equal to that of the front speakers.
To play the test signal
1. Select the “TEST” box and press ok (15) to confirm. The test signals will be played in each
speaker in a clockwise direction.
2. When the audio signal is played on a speaker, select the appropriate volume level for that
speaker from (-6 dB) to (0 dB)*.
3. Confirm the selected volume level with ok (15) . (Test signals stop.)
* 6dB corresponds to a power increase or reduction by 4 (3dB, by 2).
IB5400GB 3/09/01 16:14 Page 27