Filter
Top Products
7
Channel set-up
EN
To carry out the automatic set-up procedure again, put the set in standby mode, then press the VOL- button on the front of
the set and the MENU button on the remote control at the same time for five seconds.The set comes on and the
installation menu appears.
Manual channel set-up
Follow the procedure given on this page if you find that some channels have not been stored during the initial set-up.This
can happen if you are setting up cable network channels. Setting up channels manually requires every setting for a particular
channel to be entered, one at a time.
Display the
OVERVIEW menu by pressing the MENU button. Select the
Installation option and press OK to confirm. Select the Manual
Instal.
option from the INSTALLATION menu and press ok to
confirm.
1. Select the Standard option and then the relevant standard for your country using the buttons.
Note: the following standards are available to choose from: UK for the UK and Ireland, FR for France and Luxembourg, DK for Eastern Europe,
the Middle East and Asia,
EURO for Western Europe,Australia and New Zealand.
2. Select the Frequency option. Use the or button to start the search in ascending or descending order.When a
channel is found pictures appear.
3. If the picture is not clear you can adjust the setting.You do this by selecting the option under Frequency and adjusting
it with the buttons.
4. If the channel is encrypted and you want to connect a decoder, select the Decoder option and check the box by
pressing the OK button.
5. Then select the Character set option and choose the character set that will be used for Teletext on this channel using
the buttons.The following character sets are available:
1 :Western Europe
2 : Eastern Europe
3 : Russian and Bulgarian
4 : Greek
5 :Arabic
6 : Ukrainian
7 : Belarussian
The character set selected determines how characters are displayed on Teletext screens.
6. Select the PR option to assign a number to the channel. Enter the number using the numeric buttons. Press the OK
button to confirm.
Important: as soon as you change a setting in the MANUAL INSTALLATION menu the channel number starts flashing under the PR
option.To confirm your change you must select the PR option and press OK. If you do not confirm the change it will be cancelled when you
change channel or put the television into standby mode.
Repeat this procedure to find other channels.
MANUAL INSTALLATION
Return
Standard UK...
Frequency 150.75 MHz
PR 05
Decoder
Character set 1...
ITC008-EN-2 24/03/04 13:06 Page 7