Filter
Top Products
4.1 Searching broadcasting services 35
1.
Choose your desired satellite at the Satellite Name op-
tion.
2. Set the Search Mode option to Manual.
3.
Choose your desired transponder at the Frequency op-
tion or enter it with the numeric buttons.
4.
Enter the symbol rate of your desired transponder to the
Symbol Rate option with the numeric buttons.
5.
Set the Polarization option to the polarization of your
desired transponder.
6.
If you set the Network Search option to On, the digital
receiver willcheck up theup-to-date channelinformation
as searching services, but it takes rather longer time.
7.
Set the Modulation option to the modulation type of your
desired transponder. If your desired transponder has
high definition broadcasts, you should set this option to
DVB-S2 QPSK or DVB-S2 8PSK. Then the FEC option
and thePilot option willbecome enabled. Youalso should
set these options correctly.
NOTE
You may get transponder information from a satellite magazine
or web site such as
http://www.satcodx.com
or
http://www.
lyngsat.com.
Searching one service of a transponder
To search one service of a transponder, perform the following
steps:
1.
Choose your desired satellite at the Satellite Name op-
tion.
2. Set the Search Mode option to Advanced.
3.
Choose your desired transponder at the Frequency op-
tion or enter it with the numeric buttons.