Filter
Top Products
Chapter 7: Picture and sound controls
49
Adjusting the picture
Selecting the picture mode
You can select your desired picture settings from the
modes described below.
Mode Description
AutoView
®
Automatically adjusts picture settings
based on ambient light conditions
and input signal content.
Sports Bright and dynamic picture.
Standard Standard picture settings.
Movie 1
Lower contrast for darkened room.
Movie 2
Game
Designed for playing a video game
requiring split-second timing
between the screen display and input
from the controller.
PC
Designed for the viewing of PC
tables and documents.
Note:
•
PC mode is available for HDMI and PC inputs
only (not displayed for other input sources).
•
Game mode cannot be turned on when the
ANT/CABLE input is selected.
1無
> Settings > PICTURE > Picture Mode.
2無
Press t or u to select a mode. Press .
Note:
•
The picture mode you select affects the
current input only. You can select a different
picture mode for each input.
•
The picture mode can be changed to Game
mode by pressing when the input mode
is ColorStream HD, PC, VIDEO, or HDMI.
Adjusting the picture quality
The adjustments you make to picture quality under a
picture mode are saved to that picture mode.
Selection Pressing t Pressing u
Backlight* darker lighter
Contrast lower higher
Brightness darker lighter
Color paler deeper
Tint reddish greenish
Sharpness softer sharper
*
Backlight: Adjusts the brightness of the entire screen.
When in video mode and no signal is input, this
selection is set to 0. (Settings are stored in memory.)
Note: Some settings cannot be adjusted in any
of the following cases.
•
AutoView is selected.
•
TheaterLock is set to On.
To adjust the picture quality:
1無
> Settings > PICTURE > the setting you
would like to adjust (Backlight, Contrast,
Brightness, Color, Tint, or Sharpness).
2無
Press t or u to adjust the setting. Press .
Note:
•
Any picture settings that you adjust affect the
current input only. You can adjust the picture
quality separately for each input.
•
Depending on a Sharpness value, the Edge
Enhancer effect may be reduced.
To reset to the factory defaults:
1無
Select the picture mode you want to reset.
2無
> Settings > PICTURE > Reset > .
A confirmation screen appears.
3無
Press t or u to select Yes. Press .