Filter
Top Products
English - 12 -
Initial Installation - Digital & Analogue
Before switching on the television put your decoder and media recorder to Standby if they are connected
and ensure the aerial is connected to your television. To set up the television use the buttons on the remote
control as detailed on page 4.
Connect the mains plug and switch the TV into 1.
standby using the side On/Off switch. Press
any numbered or standby button on the remote
control, then the language selection menu will be
displayed. This screen will appear the fi rst time
that the television is switched on and each time
the television is reset.
By pressing the Up or Down buttons highlight the 2.
language you want to set and press OK button.
Afterwards, the following message will be displayed
on the screen:
Select Yes by using Left or Right buttons and 3.
press OK to continue. The Auto tuning screen
will appear and the television will start to search
for available stations. The progress bar will move
along the line. You must allow the television to
complete the search.
After Automatic Search is completed, the following 4.
message asking for analogue channel search
appears on the screen. Select Yes by using Left
or Right buttons and press OK to continue.
Select your Country, Language and Text language 5.
by using navigation buttons. Press OK or RED
button to continue. To cancel, press the BLUE
button.
Note :
For proper functioning of digital teletext in DTV •
mode, you should set country as UK in analogue
AUTO PROGRAM (for UK broadcasts only).
Do not turn off the TV while initializing fi rst time •
installation.
Auto Tuning
As new services are broadcast, it will be necessary to
re-tune the television in order to view them.
Auto Tuning will completely re-tune the television
and can be used to update the channel list. It is
recommended that Auto Tuning is run periodically to
ensure that all new services are added. All current
channels and settings, i.e. locked channels, will be
lost.
Select the • SETUP from the main menu by using
Up or Down buttons. Press OK and Setup menu
will be displayed.
Select the • Installation from the Setup menu
by using Up or Down buttons. Press OK and
Installation menu will be displayed.
Select• Automatic Channel Scan from the Installation
menu by using Up or Down buttons and press OK.
A screen will appear warning that previous digital
programmes and settings will be deleted. Select Yes
and press OK to continue with the Auto tuning.
The television will start to search for all available •
stations.You must allow the television to complete
the search. When the search is complete the Auto
tuning screen will display the total number of
services found.
After search is completed for digital channels, a •
message asking whether to search for analogue
channels appears on the screen:
Press the • OK button to search for analogue
channels. The following menu appears on the screen
for analogue channel search:
00_MB45M_[GB]_3910UK_IDTV_SILVER8_32740W_(IB_INTERNET)_10068433.indd 1200_MB45M_[GB]_3910UK_IDTV_SILVER8_32740W_(IB_INTERNET)_10068433.indd 12 30.03.2011 14:31:3130.03.2011 14:31:31