Filter
Top Products
53
Setting up your TV
Auto Tuning
v You must set up the ANT/CABLE input source before
programming channels. See “ANT/CABLE IN” on page 51.
v The automatic channel programming process will erase
channels that were previously programmed into the TV’s
memory.
v To tune the TV to a channel not programmed in the channel
memory, you must use the Channel Number buttons on the
remote control.
v Programming channels when the ANT/CABLE input is
configured for Cable will take substantially longer than when the
antenna input is configured for Antenna. This is normal;
however, once channel programming is finished, you should not
have to repeat the programming process again unless your Cable
TV service lineup changes significantly.
To program channels automatically:
1 Congure the antenna input source, if you have not already
done so, see “ANT/CABLE IN” on page 51.
2 Press the MENU button and open the Installation menu.
3 Highlight Channel Tuning, and then press the ENTER button.
Turning
(Sample Image) Setup menu - Installation selection
4 Highlight Auto Tuning, and then press the ENTER button to
open the Channel Program menu to begin channel
programming.
Cable
Scanning channels, please wait...
Number of Channels Found - 7
Scanning Analog Channels
6%
Channel - 9
Cancel
!
(Sample Image) Installation menu - Channel selection