Filter
Top Products
5
LV1737 (E/F) Web 213:276
Choosing a location for your LCD TV
To Display your LCD TV on the included Pedestal
Stand:
Observe the following safety precautions:
1) Read and Follow the pedestal assembly instructions included
with the pedestal.
CAUTION: Before beginning pedestal assembly, carefully lay
the front of the LCD Panel face down on a flat, cushioned
surface such as a quilt or blanket. Leave the bottom of the unit
protruding over the edge of the surface and assemble the
pedestal as indicated below.
Note: Extreme care should always be used when attaching
the pedestal stand to avoid damage to the LCD panel.
2) Place the TV on a sturdy, level surface that can support the
weight of the TV.
3) Be sure to secure the TV to a wall, pillar, surface, or other
immovable structure. To secure the TV in this manner, use the
included strap located at the rear of pedestal stand. (- item 20,
page 3).
To Display your LCD TV using a Wall Bracket:
If you decide to wall mount your LCD TV, always use a UL-
listed wall bracket appropriate for the size and weight of the
LCD TV (- page 2) :
1) CAUTION: Two people are required for installation.
2) Unplug and remove any cables and/or other component
connectors from the rear of the TV.
3) Follow the instructions provided with your wall bracket.
Before proceeding, make sure the appropriate bracket(s) are
attached to the wall and the back of the TV as described in the
instructions provided with the wall bracket.
4) After attaching the appropriate bracket(s) to the wall and the
back of the TV, remove the pedestal stand from the TV as
described below.
Removing the Pedestal Stand
1) Carefully lay the front of the unit face down on a flat,
cushioned surface such as a quilt or blanket. Leave the stand
protruding over the edge of the surface.
Note: Extreme care should always be used when removing
the pedestal stand to avoid damage to the LCD panel.
2) Remove the jack pack cover on the back of the TV to expose
the pedestal stand screws. The jack pack cover can be removed
without tools.
3) Remove the five screws shown in the diagram below. This will
allow removal of the pedestal stand.
4) Once you have removed all five screws holding the pedestal
stand in place, remove the pedestal stand from the TV by
sliding the pedestal stand away from the TV.
Safety and Care Information for
TV/DVD Combination Models
DISC SLOT
• Keep your fingers well clear of the disc slot when the disc is
loading or unloading. Neglecting to do so may cause personal
injury.
LASER BEAM
• Never look into the opening of the disc slot or ventilation
opening of the product to see the source of the laser beam.
Staring directly at the beam may cause permanent damage to
your eyesight.
DISC
• Do not use a cracked, deformed, or repaired disc. These discs
are easily broken and may cause serious personal injury and
product malfunction.
Precautions
VIBRATION
• Vibration or shock may disrupt DVD playback or cause
scratches on the disc. Do not move or tilt or otherwise jolt the
TV when a disc is loaded. The playback sound may skip if the
TV is dropped from a height of 1.58 inch (4 cm) or more or if
the TV is installed at a greater angle than recommended.
Notes on moisture condensation
Moisture condensation occurs, for example, when you pour a
cold drink into a glass on a warm day. Drops of water form on
the outside of the glass. In the same way, moisture may
condense on the optical pick-up lens inside the DVD player,
one of the most crucial internal parts of the DVD player.
Moisture condensation can occur in the following
conditions:
• When the TV is moved directly from a cold or air conditioned
area to a warm or humid area.
• When the TV is placed in an area in which the heat has just
been turned on, or where cold air from an air conditioner falls
directly on the TV.
Five screws
E
x
a
m
p
l
e
o
f
m
o
i
s
t
u
r
e
c
o
n
d
e
n
s
a
t
i
o
n
!
Optical pick-up
lens
(continued)
32LV1737_EN.book Page 5 Monday, April 23, 2007 1:54 PM