Filter
Top Products
12
HL86 (E/F) Web 213:276
Chapter 2: Connecting your TV
Connecting a VCR and Cable box
You will need:
• coaxial cables
• standard A/V cables
– For better picture performance, if your VCR has S-video,
connect an S-video cable and standard (analog) audio
cables to the VIDEO-2 inputs on the side panel (instead of
the VIDEO-1 inputs). Do not connect both types of video
cable to VIDEO-2 at the same time or the picture
performance will be unacceptable.
– If you have a mono VCR, connect L/MONO on the TV to
your VCR’s audio out terminal using the white audio cable
only.
– When you use a Cable box, you may not be able to use
the remote control to program or access certain features
on the TV.
To view basic and premium Cable channels:
Turn OFF the VCR. Select the antenna/cable channel input
source on the TV.* Tune the TV to channel 3 or 4 (whichever
channel the Cable box output is set to). Use the Cable box
controls to change channels.
To view the VCR:
Turn ON the VCR. Select the Video 1 video input source on
the TV.*
*To select the video input source, press + on the remote control
(- page 30). To program the TV remote control to operate other
devices, see “Using the remote control to operate your other devices”
on page 19.
IN from ANT
VIDEO AUDIO
OUT to TV
LR
R
L
OUT
IN
CH 3
CH 4
IN
OUT
CH 3
CH 4
Stereo VCR
From Cable TV
Cable box
TV upper back panel
TV lower back panel
The unauthorized recording, use, distribution, or revision of
television programs, videotapes, DVDs, and other materials is
prohibited under the Copyright Law and may subject you to
civil and criminal liability.
263237HL86_EN.book Page 12 Monday, April 24, 2006 12:48 PM