Filter
Top Products
46
Toshiba 62/72CM9UA/E (E)
Reference section
Reference section
Lamp unit replacement
The light source for this TV is a projection lamp unit with a limited service life. When the lamp wears out, the picture
may become dark or black, or the lamp may fail, at which time you must replace the lamp unit.
The length of service life varies depending on product use and user settings. See “Selecting the lamp mode” on page
25 for information on switching the lamp mode.
Replacing the lamp unit
WARNING: TO REDUCE THE RISK OF
ELECTRIC SHOCK, DO NOT REMOVE TV
COVERS. NO USER-SERVICEABLE PARTS
INSIDE. REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL.
When to replace the lamp unit
If you try to replace the lamp unit by yourself, read these
instructions carefully.
You should replace the lamp unit:
• if the picture darkens and/or colors fade;
• if the screen (lamp) does not light (LED indication #3,
page 45); or
• if you hear a loud noise and the picture goes black, which
may indicate a lamp rupture (LED indication #3, page
45).
Only the replacement lamp unit model listed below
can be used with this TV.
Using any other lamp may cause damage to the TV
and/or lamp.
Model No.: D95-LMA ( Stock No. 23311168)
Important information
• NEVER look directly at the lamp when lit as eye damage
could result. ALWAYS turn off the TV by unplugging the
power cord before opening the lamp unit door and DO
NOT remove the back cover of the TV.
• The temperature of the lamp
immediately after use exceeds 200˚C.
Allow the lamp to cool for at least 1
hour before replacing it, touching it
before it has cooled will result in severe
burns.
• When replacing the lamp unit ALWAYS wear gloves to
reduce the risk of burns.
• The lamp unit door is provided with an interlock to
reduce the risk of electric shock and excessive ultraviolet
radiation.
• DO NOT attempt to replace the lamp unit without
removing the lamp unit door completely, failure to do so
could result in serious injury or death.
• If the lamp unit glass is accidentally touched or gets dirt
on it, it can be gently wiped clean with a lint-free
cleaning cloth such as a camera lens cloth or spectacles
cloth.
NEVER clean the lamp with any type of flammable or
aerosol cleaning liquid. Most household cleaning agents
contain chemicals that are flammable at high
temperatures.
• The lamp unit contains mercury. Disposal of mercury
may be regulated due to environmental considerations.
Dispose of the used lamp unit by the approved method
for your area. For disposal or recycling information,
please contact your local authorities.
#01E44-50_6272CM9UAE 05.10.18, 3:23 PM46
Black
http://www.pureglare.com.au