Filter
Top Products
47
Toshiba 62/72CM9UA/E (E)
Introduction
Getting started
Using the
TV’s features
Equipment
connections
Reference section
Viewing teletext
Turn off the TV and remove the power plug from the
wall outlet.
Allow the lamp to cool for at least 1 hour
before replacing it.
On the lamp unit door on the side of the TV, loosen
the screw using a manual screwdriver, and then
remove the lamp unit door.
Using a manual screwdriver, loosen the two screws
on the lamp unit.
Grasp the lamp unit handle and gently pull the lamp
unit straight out of the TV. Set the old lamp unit aside.
Remember to wear lint-free gloves when
replacing the lamp unit.
How to replace the lamp unit
Lamp unit screws
Carefully insert the new lamp unit straight into the
TV until it is fully seated.
Notes:
• Never subject the lamp unit to excessive shock.
• Never touch the lamp unit glass or otherwise get it
dirty. Doing so may affect the image quality and
reduce the service life of the lamp.
Using the manual screwdriver tighten the two
screws. Make sure that the screws are hand-tight
only, do not use an electric screwdriver to avoid
over-tightening.
Reattach the lamp unit door, making sure to insert
the hooks on the left side of the lamp unit door
inside the opening in the TV cabinet.
Replace the screw and hand-tighten using a manual
screwdriver.
Plug in the power cord and turn on the TV. After the
initial warm up period (which may take several
seconds for full picture brightness), the TV should
now operate normally.
If there is no picture, the picture is very dark or the
TV does not turn on, turn it back off and remove the
power plug from the wall outlet. Repeat steps 1 to 7
to ensure that the lamp unit has been installed
correctly.
Put the old lamp into the now empty lamp unit box
and dispose of it according to local Government
guidelines. Make sure it is out of reach of children
and animals.
If you require further assistance, contact the nearest
Toshiba Authorized Service Center or dealer.
Lamp unit door
TV back
Lamp unit door detail
Loosen screw using manual screwdriver
Note:
Wear soft, lint-free
gloves when
replacing the
lamp unit.
#01E44-50_6272CM9UAE 05.10.18, 3:23 PM47
Black
http://www.pureglare.com.au