Filter
Top Products
Introduction
Connecting
your TV
Using the
Remote Control
Setting up
your TV
Using the TV’s
Features
Appendix
Index
17
Using the remote control
Preparing the remote control for use
Your TV remote control can operate your TV and most cable
converter boxes, satellite receivers, VCRs, DVD players, and HTIBs
(home theater in a box), even if they are different brands.
If you have a Toshiba device:
Your TV remote control is preprogrammed to operate most Toshiba
devices. See page 20.
If you have a non-Toshiba device or a Toshiba device
that the remote control is not preprogrammed to
operate:
You can program the TV remote control so it will operate the other
device. See pages 18–20.
Installing the remote control batteries
1. Remove the battery cover from the back of the remote control.
2. Install two “AA” size batteries, making sure to match the + and –
signs on the batteries to the signs on the battery compartment.
3. Reinsert the battery cover in the remote control until the tab
snaps.
Note:
If your Toshiba TV remote control does not
operate all the features of your other device,
use the original remote control for that device.
Squeeze tab and
lift cover.
Caution:
• Dispose of batteries in a designated
disposal area. Do not throw batteries into a
fire.
• Attention should be drawn to the
environmental aspects of battery disposal.
• Do not mix battery types or combine used
batteries with new ones.
• If the remote control does not operate
correctly, or if the operating range becomes
reduced, replace both batteries with new
ones.
• If the batteries are dead or if you will not
use the remote control for a long time,
remove the batteries to prevent battery acid
from leaking into the battery compartment.