Filter
Top Products
9
Search Key
Displays the search screen on the monitor.
Pressing this key during playback stops playback
operation to display the search screen. If pressed
while in Playback Pause mode, the Time Shift
Search screen is displayed. To exit the search
screen, press this key again.
Buzzer Stop Key
This key flashes red when an alarm is activated,
and the Recorder’s built-in buzzer is sounded to
provide both visual and audio alarm warnings.
After Alarm Recording completion, the key
changes to steady ON (red). Press this key to
stop the buzzer. The buzzer can be disabled by
selecting "OFF" for Buzzer in the Alarm
Recording Settings. (Refer to p. 19.)
Alarm Reset Key
Hold down this key for 1 second or more to reset
alarm operation and stop Alarm Recoding.
Disk Full/Failure Indicator
Disk Full Indicator
When the Recording mode is set to "STOP" or
"SERIES" in the Disk Setting, the indicator
flashes whenever less than 1 hour of available
hard disk time remains, and changes to steady
ON if no available time remains.
Failure Indicator
This indicator lights red when the Recorder fails,
and extinguishes when the cause of the failure is
removed. This failure indication takes precedence
over the Disk Full indication, should both be
enabled at the same time. Possible Failure
Causes: Hard disk failure, fan failure, and video
loss.
Note
If the Recorder should indicate a failure, first
check for the cause by switching the power OFF,
then contact your TOA dealer if unable to solve
the problem.
Video Output Terminal
Used for dubbing recorded video images. This
terminal is the same as the Video Output
Terminal located on the rear panel.
Audio Output Terminal
Used for dubbing recorded audio signals. This
terminal is the same as the Audio Output
Terminal located on the rear panel.
16
15
14
13
12