Filter
Top Products
14
Using the
Remote Control
Programming the remote control for use
with a VCR or cable TV converter
The remote control provided with your Toshiba TV is preprogrammed
to operate Toshiba VCRs also.
To operate non-Toshiba components using
the remote control provided with your TV:
1. Refer to the VCR and cable TV converter code table below to
find the corresponding code for your VCR or cable TV converter
brand.
If more than one code is listed, try each one separately until you
find the one that works.
2. If you are reprogramming the remote control to operate your:
• VCR: Set the TV/CABLE/VCR switch on the remote control
to VCR.
• Cable TV converter: Set the TV/CABLE/VCR switch on the
remote control to CABLE.
3. Hold down the RECALL button while using the Channel
Number buttons to enter the three-digit code of your VCR or
cable TV converter brand.
4. Point the remote control at the VCR or converter and press
POWER to test the code.
• If the VCR or converter turns on, you have entered the
correct code.
• If the VCR or converter does not respond to the remote
control, you may have entered the incorrect code.
Repeat steps 1–4 using another code.
5. Reset the TV/CABLE/VCR switch to TV to control the TV.
For future reference, write down the codes you used:
VCR code _____________________
Cable TV converter code _____________________
Note:
• When the batteries are replaced, the
remote control must be reprogrammed.
• Some VCRs can use either of two remote
control codes. These VCRs have a switch
labeled “VCR1/VCR2.” If your VCR has this
kind of switch and does not respond to any
of the VCR codes, set the switch to the
other position (VCR1 or VCR2) and
reprogram the remote control.
CH RTN
ADV/
PIP CH
LIGHT
MUTE TV/VIDEOTIMER
RECALL
POWER
TV
CABLE
VCR
ENT
ENTER
FAV
FAV
C.CAPT
MENU
1
4
2
5
3
6
7
8
9
0
100
Channel
Numbers
TV/CABLE/VCR
switch
ENT (used for the “ENTER”
command with some VCRs
and cable TV converters)
POWER
CH
CH (Channel)
VOL
RECALL