Filter
Top Products
19
Reference
Welcome to
Toshiba
Connecting
your TV
Using the
Remote Control
Setting up
your TV
Using the TV’s
Features
Appendix
Index
Using the TV/VIDEO button
You can monitor or change the signal source that is connected to the TV.
By pressing the TV/VIDEO button on the TV, you can select the
VIDEO 1, VIDEO 2, ColorStream, ANT 1 or ANT 2 mode. The signal
source you are currently connected to will be displayed in purple.
To select the antenna input:
1. Press the TV/VIDEO button on the TV. The signal source you
are connected to is displayed in purple.
TO SELECT PUSH TV/VIDEO
VIDEO 1 ANT 1
COLOR
STREAM
TV
VIDEO 2 ANT 2
2. Press the button until ANT 1 or ANT 2 is displayed in purple,
indicating the antenna terminal you wish to use.
Adding channels to the TV’s memory
Your TV will stop on specific channels that are stored in the TV’s
channel memory when you press Channel
▲ or ▼. Use the steps below
to set all active channels in your area automatically.
Programming channels automatically
Your TV can automatically detect all active channels and store them in
its memory. After the TV has stored the channels in its memory, you
can erase channels or add your favorite channels. If you use both
ANT-1 and ANT-2 terminals, you must program channels for each
input source.
To add channels:
1. Press MENU, then press
x or • to highlight the SET UP menu.
2. Press y or z until the TV/CABLE selection is highlighted.
3. Press
x or • to highlight either TV or CABLE, depending on
which you use.
LANGUAGE:
ANT1/2:
TV/CABLE:
CH PROGRAM
MORE
SELECT[ ]
[ENGLISH]FRANCAIS
ESPANOL
[ANT1]ANT2
[TV]CABLE
ADD/ERASE:
[ADD]ERASE
AUDIO
PREFER
SET UP
C.CAPT
PICTURE
If you use an antenna, choose TV. If you use cable, choose
CABLE.
4. Press
z to select CH PROGRAM.
5. Press x or • to start channel programming. The TV will automati-
cally cycle through all the TV or Cable channels (depending on
which you selected), and store all active channels in the
channel memory.
While the TV is cycling through the channels, the message “CH
PROGRAM” appears.
6. When channel programming is complete, the message “CH
Completed (channel or cable number)” appears.
7. Press Channel
▲ or ▼ to view the programmed channels.
MENU TV / VIDEO VOLUME CHANNEL
POWER
CH RTN
ADV/
PIP CH
ADV/
PIP CH
LIGHT
MUTE TV/VIDEO TIMER
RECALL
POWER
TV
CABLE
VCR
ENT
ENTER
FAV
FAV
C.CAPT
EXIT
MENU
RESET
1
4
2
5
3
6
7
8
9
0
100
EXIT
MENU
CH
VOL
TV/VIDEO